Oil-waxes for covering carved wood items STRYI, volume 150 ml, Covering wood

 Oil-wax is intended for protection and decorative finishing of wooden walls, ceilings, doors, plinths, decorative beams, products from glued wood and other wooden surfaces.

In our range there different types of oil-waxes: with carnauba basis and bee bassis.
It is made on the basis of linseed oil thanks to what moisture easily leaves wood without formation of swelling of a covering. By hardening in the pores, the oil increases the resistance of the surface layer of wood to abrasion.

Due to the wax content, the oiled surface is water-repellent, and the wax hides scratches and damage to the coating. Suitable for processing previously oiled wood products.
The coating gives the wood water-repellent properties, prevents water penetration, leaving the pores of the wood surface open (wood breathes) and protects it from drying out.

Using:

Surface preparation:
The treated surface must be dry, thoroughly cleaned of dirt, wax and grease. Harder woods containing resins and natural oils should be cleaned with a cloth soaked in an organic solvent.

Application:
The product is ready to use. Stir before use and during operation. Apply in a continuous layer in the direction of the wood fibers. Treat the surface to saturation with a brush 1-2 times. Excess oil not absorbed into the wood should be removed with a rag no later than 1 hour after application. At least 2 coats are recommended, can be re-applied after 12 hours. For planed as well as very dense wood due to lower absorption capacity, it is recommended to apply the 3rd layer if necessary.